Remote Control Commands
R&S
®
SMW200A
1125User Manual 1175.6632.02 ─ 16
Example: See Example "Finding out the used VISA ressource strings"
on page 1116.
Usage: Query only
:SYSTem:COMMunicate:NETWork:IPADdress <IpAddress>
Sets the IP address.
Parameters:
<IpAddress> string
Range: 0.0.0.0. to ff.ff.ff.ff
Example: See Example "Retrieving information on network-related set-
tings" on page 1115.
Manual operation: See "IP Address" on page 716
:SYSTem:COMMunicate:NETWork:IPADdress:MODE <Mode>
Selects manual or automatic setting of the IP address.
Parameters:
<Mode> AUTO | STATic
*RST: n.a. (factory preset: AUTO)
Example: See Example "Retrieving information on network-related set-
tings" on page 1115.
Example:
SYSTem:COMMunicate:NETWork:IPADdress:MODE STATic
SYSTem:COMMunicate:NETWork:IPADdress "10.113.0.105"
Manual operation: See "Address Mode" on page 716
:SYSTem:COMMunicate:NETWork:MACaddress <MacAddress>
Queries the MAC address of the network adapter.
This is a password-protected function. Unlock the protection level 1 to access it, see :
SYSTem:PROTect<ch>[:STATe].
Parameters:
<MacAddress> string
Example: See Example "Retrieving information on network-related set-
tings" on page 1115.
Manual operation: See "MAC Address" on page 716
:SYSTem:COMMunicate:NETWork:RESource?
Queries the visa resource string for Ethernet instruments.
SYSTem Subsystem
To Next Page
Loading...
