Rohde & Schwarz SMW200A - Page 1141

Remote Control Commands
R&S
®
SMW200A
1126User Manual 1175.6632.02 ─ 16
Return values:
<Resource> string
Example: See Example "Finding out the used VISA ressource strings"
on page 1116.
Usage: Query only
:SYSTem:COMMunicate:NETWork:RESTart
Restarts the network.
Example:
SYSTem:COMMunicate:NETWork:RESTart
// Terminates the network connection and sets it up again
Usage: Event
Manual operation: See "Restart Network" on page 718
:SYSTem:COMMunicate:NETWork:STATus?
Queries the network configuration state.
Return values:
<State> 0 | 1 | OFF | ON
Example: See Example "Retrieving information on network-related set-
tings" on page 1115.
Usage: Query only
Manual operation: See "Network Status" on page 715
:SYSTem:COMMunicate:NETWork[:COMMon]:DOMain <Domain>
Determines the primary suffix of the network domain.
Parameters:
<Domain> string
Example: See Example "Retrieving information on network-related set-
tings" on page 1115.
Manual operation: See "DNS Suffix" on page 717
:SYSTem:COMMunicate:NETWork[:COMMon]:HOSTname <Hostname>
Sets an individual hostname for the R&S SMW.
Note:We recommend that you do not change the hostname to avoid problems with the
network connection. If you change the hostname, be sure to use a unique name.
This is a password-protected function. Unlock the protection level 1 to access it, see :
SYSTem:PROTect<ch>[:STATe].
SYSTem Subsystem