Maintenance
R&S
®
SMW200A
1164User Manual 1175.6632.02 ─ 16
5. On the instrument, connect the selected "Source" connector with the "Destination"
connector.
The selection list in the dialog shows you where to find the associated connector
on the instrument.
6. Select "Execute BNC Connection Test".
Execute Baseband Connection Test
Performs a connection test on each of the internal digital baseband links.
The test implies to all installed options as baseband inputs, motherboard, universal
coding generators, fading simulators, and baseband outputs.
The result (succeeded or failed) is displayed in the status field on the right.
Remote command:
n.a.
BNC Connection Test
This function is password-protected. Unlock the protection level 1 to access it, see
"Protection Level/Password" on page 688.
Source ← BNC Connection Test
Selects the BNC connector source to be tested.
Remote command:
:TEST:BB:BNC:SOURce on page 1143
Destination ← BNC Connection Test
Selects the BNC connector destination to be tested.
Remote command:
:TEST:BB:BNC:DESTination on page 1142
Execute BNC Connection Test ← BNC Connection Test
Performs the BNC connection test at the selected connectors.
Remote command:
:TEST:BB:BNC:CONNection? on page 1142
Log Message ← BNC Connection Test
Displays the log message reported during the BNC connections test.
Remote command:
:TEST:BB:BNC:LOG? on page 1143
14.3.5 Selftest Test Generator Settings (DAC)
This function is password-protected. Unlock the protection level 1 to access it, see
"Protection Level/Password" on page 688.
Performing Maintenance Tasks
To Next Page
Loading...
