Rohde & Schwarz SMW200A - Versions;Options Settings

Maintenance
R&S
®
SMW200A
1169User Manual 1175.6632.02 ─ 16
"Slot"
Indicates whether the assembly is connected to the serial bus or PCI
bus.
Remote command:
:DIAGnostic<hw>:BGINfo? on page 795
Counter
Displays information on the operation times of the R&S SMW.
Operation Time / h ← Counter
Displays the operation time in hours.
Remote command:
n.a.
Power On Count ← Counter
Displays the number of power-on.
Remote command:
n.a.
Last Factory Calibration ← Counter
Displays the date of the last factory calibration.
Remote command:
:CALibration:DATA:FACTory:DATE? on page 789
14.3.8.2 Versions/Options Settings
Access:
► Select "System Config > Setup > Instrument Assembly > Versions / Options".
Performing Maintenance Tasks