Maintenance
R&S
®
SMW200A
1170User Manual 1175.6632.02 ─ 16
The "Versions/Options" dialog shows the version of the installed instrument firm-
ware, the hardware and software options, the data sheet and the software compo-
nents of the firmware.
The remote commands required to query the hardware configuration are described in
Chapter 13.10, "DIAGnostic Subsystem", on page 794.
Firmware
Shows the firmware version and the version of the software platform.
Note: Your instrument is delivered with the latest firmware version available.
You can download firmware updates and the "Release Notes" that describe the modifi-
cations and the firmware update procedure.
See www.rohde-schwarz.com/firmware/smw200a
Remote command:
n.a.
Downgrade Info
Shows downgrade information, like factory firmware version and minimum firmware
version to that the instrument can be downgraded.
Remote command:
n.a.
Show Open Source Acknowledgments
Accesses the list of the used open source software packages and the corresponding
verbatim license texts.
Hardware Options/Software Options
The tables in the "Hardware" and "Software" tabs list the installed hardware and soft-
ware options.
"Option"
Short name of option
"Designation"
Name of option
"Licenses"
(optional)
Number of licenses.
The licenses for the software options are "floating licenses". In the
case of two-path instruments, just one license is required to use the
option for either of the two paths. However, two licenses must be pur-
chased to use an option on both paths simultaneously.
"Expiration Date"
For regular options, "Permanent" is indicated in this column. Some
options are available as trial versions. This column shows their expi-
ration date. After this date, the option is no longer available on the
instrument.
Remote command:
*OPT? on page 771
*IDN? on page 770
Performing Maintenance Tasks
To Next Page
Loading...
