Getting Started
R&S
®
SMW200A
120User Manual 1175.6632.02 ─ 16
1 = Information on the performed action
2 = Progress bar
3 = "Next Step": confirms the execution of the step
4 = "Stop": terminates the tutorial
8. To execute a subsequent step, select the "Next Step" button.
A blinking cursor indicates the block or parameter affected by the step.
The instrument performs the configurations step-by-step and expects your confir-
mation. Dialogs are opened and closed; changed parameters are highlighted in
orange.
Additional information is displayed in the "Info" line.
To stop the tutorial
The demonstration can be terminated at any time.
► Select the "Stop" button.
The demonstration stops.
You may reopen the "Tutorials" dialog and start another file or exit the tutorial
mode.
To use the demonstration mode
1. Start the tutorials as described in "To start a tutorial in an interactive step-by-step
mode" on page 118.
2. In the "Tutorials" dialog, select "Execution Mode > Auto (Looped) 3 sec".
The configurations are performed automatically; your interaction is not required.
Dialogs are opened and closed; changed parameters are highlighted in orange.
Additional information is displayed in the "Info" line.
See also:
●
Chapter F, "Available Tutorial Files", on page 1243
●
The application sheet "RS_SMW_CreatingTutorials_AppSheet", available for
download from the R&S website, on the R&S SMW product page.
Instrument Control
To Next Page
Loading...
