Rohde & Schwarz SMW200A - Fading and Baseband Configuration Settings

Signal Routing and System Configuration
R&S
®
SMW200A
138User Manual 1175.6632.02 ─ 16
For a step-by-step description of how to use the provided settings, refer to Chapter 3.9,
"How to Connect External Instruments and Configure the Signal Flow", on page 191 .
Required options
The equipment layout for the generation of complex signals (Advanced mode)
includes:
●
2 options standard baseband generator (R&S SMW-B10)
(incl. one digital interfaces CODER 1/2 per installed option)
●
Option baseband main module, two I/Q paths to RF (R&S SMW-B13T)
●
Up to four options fading simulator (R&S SMW-B14)
(incl. one digital interfaces FADER 1/2/3/4 per installed option)
●
Option MIMO fading (R&S SMW-K74)
●
Optional option higher-order MIMO (R&S SMW-K75)
●
Optional option multiple entities (R&S SMW-K76)
●
Optional option Slow IQ (R&S SMW-K551)
●
Optional option steam extender (R&S SMW-K550)
●
Optional option MIMO subsets (R&S SMW-K821)
The equipment layout for the generation of wideband signals (Standard mode)
includes:
●
2 options wideband baseband generator (R&S SMW-B9)
●
Option wideband baseband main module (R&S SMW-B13XT)
Settings:
For description of the "Multi-Instrument" settings, see Chapter 9.3.1.1, "Multi-Instru-
ment Settings", on page 609.
This section described the following settings.
● Fading and Baseband Configuration Settings...................................................... 138
● I/Q Stream Mapper Settings..................................................................................144
● External RF and I/Q Settings................................................................................ 147
● Overview............................................................................................................... 164
3.4.1 Fading and Baseband Configuration Settings
Access:
► Use one of the following:
● Select "Taskbar > System Config > System Configuration > Fading/Baseband
Config"
● Select "Block Diagram > Fading > System Configuration > Fading/Baseband
Config"
System Configuration Settings