Rohde & Schwarz SMW200A - Mode; Set to Default; Signal Outputs

Signal Routing and System Configuration
R&S
®
SMW200A
140User Manual 1175.6632.02 ─ 16
└ Streams (Rx Antennas).................................................................................142
Subset.........................................................................................................................142
Baseband Source Configuration................................................................................. 143
Duplicate Streams.......................................................................................................143
Apply........................................................................................................................... 144
Ok................................................................................................................................144
Set to Default
Presets the signal routing in the baseband section and the fading configuration to the
default state.
Remote command:
:SCONfiguration:PRESet on page 834
Mode
Switches between standard and advanced mode.
Execute "Apply" to trigger the instrument to adopt the selected configuration.
"Standard"
Provided for non-MIMO configuration.
"Advanced"
Depending on the installed hardware and software options, enables
the configuration of:
●
Complex MxN MIMO scenarios with up to 8 Tx or Rx antennas,
e.g. 4x4, 2x8, or 8x2 MIMO
●
multiple entity scenarios with up to four standalone 2x2 MIMO
systems, e.g. 4x2x2 scenarios
●
Up to 8 SISO systems, e.g. 8x1x1 scenarios
See also:
●
Chapter 3.9.3, "How to Define the MIMO Scenario", on page 193
●
Chapter 3.9.7, "How to Generate a 2x8 MIMO Signal for BS
Tests", on page 207
"Radar Echo
Generation
(REG)"
Option: R&S SMW-K78
Enables the R&S SMW to work as a radar echo generator.
The fading simulator is disabled.
See user manual R&S®SMW-K78 Radar Echo Generation.
Remote command:
:SCONfiguration:MODE on page 834
Signal Outputs
Defines whether an analog and digital or digital only signal is generated.
"Analog&Digital"
In this default mode, the instrument generates signals with high data
rate.
Generated streams can be mapped to the analog connectors and to
the digital I/Q interfaces.
System Configuration Settings