Rohde & Schwarz SMW200A - Page 161

Signal Routing and System Configuration
R&S
®
SMW200A
146User Manual 1175.6632.02 ─ 16
Phase, deg
Sets the phase offset of the corresponding stream.
Remote command:
:SCONfiguration:OUTPut:MAPPing:STReam<st>:POFFset on page 841
Map Stream X to Connector
The mapping of the generated streams to the output connectors is represented as a
stream matrix. A blue circle at a matrix element routes the selected stream to the cor-
responding connector.
To map more than one stream to an output connector, enable the Combination Mode.
The stream mapping to the FADER connectors is fixed.
Remote command:
:SCONfiguration:OUTPut:MAPPing:RF<ch>:STReam<st>:STATe on page 840
:SCONfiguration:OUTPut:MAPPing:IQOutput<ch>:STReam<st>:STATe
on page 840
:SCONfiguration:OUTPut:MAPPing:BBMM<ch>:STReam<st>:STATe
on page 840
:SCONfiguration:OUTPut:MAPPing:FADer<ch>:STReam<st>:STATe?
on page 840
Combination Mode
Defines the way the streams are internally processed if multiple streams are routed to
the same physical connector.
Tip: Use the parameter f
offset
, MHz to shift the frequency bands of the streams in the
frequency domain.
"Single"
One stream can be routed to several connectors but only one stream
can be mapped on each connector.
"Add"
If more than one stream are routed to the same RF, I/Q or BBMM
connector, they are added equally weighted.
"Mux"
(requires option R&S SMW-K551)
Enables stream multiplexing at the digital connectors. The exact
parameters are defined in the "Digital I/Q Output" dialog.
Tip: This mode is useful to output the generated signals of a higher-
order MIMO configuration at less digital connectors. The connected
instrument must support stream multiplexing.
See Chapter 3.7, "I/Q Digital Output Settings", on page 178
See user manual R&S
®
SMW-K551 Generation of Digital "Slow IQ"
Signals.
Remote command:
:SCONfiguration:OUTPut:MAPPing:RF<ch>:MODE on page 840
:SCONfiguration:OUTPut:MAPPing:IQOutput<ch>:MODE on page 840
:SCONfiguration:OUTPut:MAPPing:BBMM<ch>:MODE on page 840
:SCONfiguration:OUTPut:MAPPing:FADer<ch>:MODE? on page 840
System Configuration Settings