Signal Routing and System Configuration
R&S
®
SMW200A
163User Manual 1175.6632.02 ─ 16
3. In the "<Dig. Conn. Name>: External Instrument Configuration" dialog, select
"Show Connector".
The dialog displays the location of the selected connector.
The "Show Connector" function triggers the instrument to identify the connector on
the rear panel. The LED next to the selected connector blinks.
See also Chapter 3.3.1, "Physical Location of the Input and Output Interfaces",
on page 130.
Check Connections Settings
This dialog is available if a R&S SZU is configured and connected to the R&S SMW,
see "To connect and configure an R&S SZU" on page 204.
Access:
1. Select "Taskbar > System Config > System Configuration > External RF and I/Q".
2. Select "I/Q OUT x > External Instruments > Config ...".
3. In the "I/Q OUT x: External Instrument Configuration" dialog, select "Connections".
System Configuration Settings
To Next Page
Loading...
