Signal Routing and System Configuration
R&S
®
SMW200A
167User Manual 1175.6632.02 ─ 16
●
The external baseband signal of the first input module "BB Input A" can be fed into
path A, path B or both
●
The second baseband input module "BB Input B" is firmly connected to signal path
B
●
If internal signals from one or two paths are generated at the same time, all signals
in each path are summed.
Table 3-7: Possible baseband signal routing combinations (default instrument state)
Block in the block diagram To path A To path B To path A and B
"Baseband A" X X X
"Baseband B" X X X
"BB Input A" X X X
"BB Input B"
X
Interdependency between the "Signal Routing" settings and the "System Config-
uration" settings
The signal routing settings are enabled for the following configurations:
●
"System Configuration > Mode = Standard"
●
"System Configuration > Mode = Advanced" with maximum two "Separate Base-
band Sources", e.g. in 1x2x2, 2x1x1 or 2x1x2 configurations
See also "The meaning of the short form representations of the fading and base-
band configurations" on page 126.
For an overview of the signal routing possibilities of the faded baseband signal, refer to
Chapter 3.4.1, "Fading and Baseband Configuration Settings", on page 138.
Signal Routing Settings
To Next Page
Loading...
