Signal Routing and System Configuration
R&S
®
SMW200A
169User Manual 1175.6632.02 ─ 16
Example: Routing the signal of baseband A to the RF B output
The Figure 3-7 shows an example of the signal flow for the following settings:
●
"IQ Stream Mapper > Stream A to RF B"
●
"Baseband A > State > On"
●
"RF B > State On"
Figure 3-7: Example: Routing the signal of baseband A to the RF B output
Access:
► Use one of the following:
● "Baseband A/B > Signal Routing"
● "BB Input A/B > Signal Routing"
● "Fading > Signal Routing"
● "Taskbar > System Config > Mode = Standard > System Configuration"
Signal Routing Settings
To Next Page
Loading...
