Signal Routing and System Configuration
R&S
®
SMW200A
179User Manual 1175.6632.02 ─ 16
Figure 3-11: Representation of the digital output interface in advanced mode
1 = digital output interface state: gray = inactive; blue = active
2 = more settings indication; select to unfold detailed information
1. Select the connector icon to unfold the settings and retrieve more information on
the mapped streams and configured connectors.
1
= digital output interface state: gray = inactive; blue = active
2 = digital connector name
3 = mapped I/Q streams
Note: The number of the displayed digital output interfaces corresponds to the
number of enabled Streams (Rx Antennas) in the "System Configuration > Fading/
Baseband Configuration" dialog.
2. To (re) route the I/Q streams to the digital outputs, select the "I/Q Stream Mapper"
block.
3. To enable the baseband signal at the digital outputs, select "Block Diagram > I/Q
Digital > I/Q Digital On".
4. To access the dialog box for configuring the digital output signal, select "I/Q Digital
> I/Q Digital Outputs".
I/Q Digital Output Settings
To Next Page
Loading...
