Rohde & Schwarz SMW200A - Page 196

Signal Routing and System Configuration
R&S
®
SMW200A
181User Manual 1175.6632.02 ─ 16
If R&S SGT is connected to the DIG I/Q interface of the R&S SMW, several parame-
ters set automatically.
Settings:
State............................................................................................................................181
Sample Rate Source...................................................................................................181
Sample Rate Value..................................................................................................... 181
Connected Device.......................................................................................................181
State
Switches On/Off the digital I/Q output signals.
Remote command:
[:SOURce]:IQ:OUTPut:DIGital:BBMM<ch>:STATe on page 1056
[:SOURce]:IQ:OUTPut:DIGital:FADer<ch>:STATe on page 1056
Sample Rate Source
Selects whether the sample rate is estimated based on the digital signal or a manually
entered value.
"User Defined"
Enables you to define the sample rate in the entry field value. An I/Q
data clock is not necessary.
"Digital I/Q Out"
Estimates the sample rate based on the applied I/Q data clock and
displays the resulting value in the value field.
Remote command:
[:SOURce]:IQ:OUTPut:DIGital:BBMM<ch>:SRATe:SOURce on page 1057
[:SOURce]:IQ:OUTPut:DIGital:FADer<ch>:SRATe:SOURce on page 1057
Sample Rate Value
Sets or displays the sample rate of the digital I/Q output signal. The maximal sample
rate depends on the connected receiving device.
Remote command:
[:SOURce]:IQ:OUTPut:DIGital:BBMM<ch>:SRATe on page 1057
[:SOURce]:IQ:OUTPut:DIGital:FADer<ch>:SRATe on page 1057
Connected Device
If the connection to the external device is properly established and signal transmission
is active, this parameter displays information on the instrument connected to the DIG
I/Q interface:
●
Name and serial number of the connected instrument
●
The transmitter sample rate, if supported by the transmitter
Remote command:
[:SOURce]:IQ:OUTPut:DIGital:BBMM<ch>:CDEVice? on page 1058
[:SOURce]:IQ:OUTPut:DIGital:FADer<ch>:CDEVice? on page 1058
I/Q Digital Output Settings