Signal Routing and System Configuration
R&S
®
SMW200A
194User Manual 1175.6632.02 ─ 16
Proceed as follows:
1. To access the "Fading/Baseband Configuration" settings, use one of the following:
● Select "Taskbar > System Config > System Configuration"
● Select "Block Diagram > I/Q Stream Mapper > System Configuration > Fading/
Baseband Configuration"
● Select "Block Diagram > Fading > MIMO > System Configuration".
The "Fading/Baseband Configuration" settings are divided into two modes, the
standard mode for more simple non-MIMO configurations and the advanced mode
for complex MxN MIMO setups.
2. In the "Fading/Baseband Configuration" tab, enable "Mode > Advanced".
Set the required configuration.
a) Define the number of "Entities"
b) Define the number of "BB Signals (Tx Antennas)" and "Streams (Rx Antennas)"
Tip: Use the provided preview diagram and description to simplify the decision
process.
3. If necessary, adjust the "Baseband Source Configuration".
For example, to enable the instrument to calculate the required signals and
streams out of one baseband signal source, select "BB Source Config > Coupled
Sources"
Figure 3-15: Configuration example (Fading and Baseband Configuration > 1x4x4 and Coupled
Baseband Sources)
4. Execute "Apply" to trigger the instrument to adopt the signal routing.
The block diagram displays the configured signal routing.
How to Connect External Instruments and Configure the Signal Flow
To Next Page
Loading...
