Signal Routing and System Configuration
R&S
®
SMW200A
204User Manual 1175.6632.02 ─ 16
To connect and configure an R&S SZU
The following example assumes a differential I/Q connection between the R&S SZU
and R&S SMW, equipped with wideband baseband generator (R&S SMW-B9). The
R&S SZU is connected to RF A.
Figure 3-21: Example of test setup: 1xR&S
SMW (R&S
SMWB9) and 1xR&S
SZU connected to the dif-
ferential I/Q outputs (rear panel view)
How to Connect External Instruments and Configure the Signal Flow
To Next Page
Loading...
