Signal Routing and System Configuration
R&S
®
SMW200A
206User Manual 1175.6632.02 ─ 16
10. Open the "External Instrument Configuration > Connections" dialog.
Select "Check Confections".
Observe the connection status indications.
The green color indicates that the required physical connections are in operation.
11. In the block diagram, select "RF > On".
The R&S SMW performs the following:
● Retrieves the R&S SZU calibration data.
● Indicates the connected R&S SZU on the block diagram.
● Sets the output signal level and frequency to the default values of the R&S
SZU and indicates the value in the status bar.
Figure 3-22: Block diagram of wideband baseband R&S
SMW (R&S
SMW-B9) with connected R&S
SZU
1 = RF frequency at the R&S SZU RF output
2 = RF level, nominal level at the R&S SZU RF output (regulated level)
3 = R&S SZU, indicated as waveguide port icon, label and the serial number
4 = I/Q modulator of the R&S SZU
3, 5 = Access to the R&S SZU RF settings (RF block or icon)
6 = Active I/Q analog output, firmly routed to the R&S SZU; the example uses differential output signal
7 = I/Q analog B is disabled, because the differential output of the first path is used
8 = R&S SMW RF settings
9, 10 = RF frequency and level settings at the second R&S SMW RF output
For more information on the R&S SZU, see the description SZU100A Getting Started.
How to Connect External Instruments and Configure the Signal Flow
To Next Page
Loading...
