Signal Routing and System Configuration
R&S
®
SMW200A
211User Manual 1175.6632.02 ─ 16
Figure 3-24: Example of test setup*: 8x8 MIMO with 2xR&S
SMW and 4xR&S
SGT
blue circle = front panel connector
gray circle = rear panel connector
* = To simplify the diagram, it does not show the LAN/USB connections between the instruments
Workflow overview
1. Cabling
See "To cable the instruments" on page 212.
2. Configuring the first R&S SMW
See "To configure the R&S SMW that simulates the first subset" on page 212.
3. Configuring the second R&S SMW
See "To configure the R&S SMW that simulates the second subset" on page 213.
4. Starting signal generation
See "To start signal generation" on page 214
How to Connect External Instruments and Configure the Signal Flow
To Next Page
Loading...
