Rohde & Schwarz SMW200A - Page 269

Configuring the Internal Baseband Source
R&S
®
SMW200A
254User Manual 1175.6632.02 ─ 16
Settings:
Trigger Settings Common to All Basebands............................................................... 254
└ Trigger Mode.................................................................................................255
└ Trigger Signal Duration.................................................................................255
└ Running/Stopped.......................................................................................... 255
└ Arm............................................................................................................... 255
└ Execute Trigger.............................................................................................255
└ Trigger Source.............................................................................................. 256
└ Sync. Output to External Trigger/Sync. Output to Trigger............................ 256
└ External / Trigger Inhibit................................................................................257
(External) Delay Unit...................................................................................................257
(Specified) External Delay/(Specified) Trigger Delay..................................................257
Actual Trigger Delay/Actual External Delay................................................................ 258
Trigger Settings Common to All Basebands
To enable simultaneous signal generation in all basebands, the R&S SMW couples the
trigger settings in the available basebands in any instrument's configuration involving
signal routing with signal addition. For example, in MIMO configuration, routing and
summing of basebands or of streams.
The icon indicates that common trigger settings are applied.
Common Functions and Settings in the Baseband Domain