Contents
R&S
®
SMW200A
12User Manual 1175.6632.02 ─ 16
6.2 About the I/Q Modulator........................................................................................... 415
6.3 I/Q Modulator Settings..............................................................................................416
6.4 Frequency Response Settings.................................................................................422
6.5 How to Adjust the I/Q Modulator to Optimize Performance..................................424
7 Configuring the Signal in the RF Domain........................................ 426
7.1 How to Access the Functions in the RF Domain?................................................. 427
7.2 Required Options...................................................................................................... 429
7.2.1 Activating RF Signal Output........................................................................................ 429
7.3 Configuring RF Frequency and Level..................................................................... 430
7.3.1 RF Frequency Settings............................................................................................... 430
7.3.2 RF Level Settings........................................................................................................434
7.3.3 RF Phase Settings...................................................................................................... 439
7.3.4 References..................................................................................................................440
7.3.4.1 Displayed RF Frequency and Level Values with Downstream Instruments................440
7.4 Reference Oscillator................................................................................................. 441
7.4.1 Reference Oscillator Settings......................................................................................444
7.5 Local Oscillator Coupling.........................................................................................448
7.5.1 Required Options........................................................................................................ 450
7.5.2 Phase Coherence....................................................................................................... 450
7.5.3 LO Coupling Settings.................................................................................................. 451
7.5.4 How to Adjust the LO Level, Find the Connectors and Configure Cascaded Instruments
.................................................................................................................................... 453
7.6 Varying the RF Signal in List or Sweep Mode........................................................ 457
7.6.1 Signal Generation and Triggering in the Sweep and List Modes................................ 459
7.6.2 About Sweep Mode.....................................................................................................467
7.6.2.1 Correlating Parameters in Sweep Mode..................................................................... 467
7.6.2.2 Sweep Signal Shapes................................................................................................. 469
7.6.3 About List Mode.......................................................................................................... 470
7.6.4 Significant Parameters and Functions........................................................................ 472
7.6.5 Sweep Mode Settings................................................................................................. 474
7.6.6 List Mode Settings.......................................................................................................481
7.6.6.1 General Settings......................................................................................................... 481
7.6.6.2 List Mode Data Settings.............................................................................................. 483
To Next Page
Loading...
