Rohde & Schwarz SMW200A

To Next Page

To Previous Page

Configuring the Internal Baseband Source

R&S

SMW200A

256User Manual 1175.6632.02 ─ 16

Remote command:

[:SOURce<hw>]:BB:DM:TRIGger:EXECute on page 907

[:SOURce<hw>]:BB:ARBitrary:TRIGger:EXECute on page 955

[:SOURce<hw>]:BB:MCCW:TRIGger:EXECute on page 996

Trigger Source ← Trigger Settings Common to All Basebands

The following sources of the trigger signal are available:

●

"Internal"

The trigger event is executed manually by the "Execute Trigger".

●

"Internal (Baseband A/B)"

The trigger event is provided by the trigger signal from the other basebands.

If common trigger settings are applied, this trigger source is disabled.

●

"External Global Trigger 1 / 2"

The trigger event is the active edge of an external trigger signal provided and con-

figured at the global USER connectors.

●

"External Local Trigger"

The trigger event is the active edge of an external trigger signal provided and con-

figured at the local T/M/C connector.

With coupled trigger settings, the signal has to be provided at the T/M/C1/2/3 con-

nectors.

●

"External Local Clock"

The trigger event is the active edge of an external local clock signal provided and

configured at the local T/M/C connector.

With coupled trigger settings, the signal has to be provided at the T/M/C1 connec-

tor.

●

"Baseband Sync In"

Option: R&S SMW-B9

In master-slave mode, slave instruments are triggered by the active edge of the

synchronization signal.

"External Local Clock/Trigger" require R&S SMW-B10.

The polarity, the trigger threshold, and the input impedance of the input connectors can

be configured in the "Global Connector Settings" and "Global Connector Settings" dia-

log.

Rohde & Schwarz SMW200A - Page 271