Rohde & Schwarz SMW200A - 4.6.3 Custom Digital Modulation Settings; Custom Digital Modulation Settings; Settings: General Settings

Configuring the Internal Baseband Source
R&S
®
SMW200A
265User Manual 1175.6632.02 ─ 16
4.6.3 Custom Digital Modulation Settings
Access:
► Select "Baseband > Custom Dig Mod".
The "Custom Digital Modulation" dialog enables direct selection of the data source,
standard, symbol rate, coding, modulation type and filter.
The dialog is divided into several tabs. In each case, the current setting is dis-
played in the tab name.
The remote commands required to define these settings are described in Chap-
ter 13.18.4.2, "SOURce:BB:DM Subsystem", on page 890.
Settings:
● General Settings................................................................................................... 265
● Trigger, Marker and Clock Setting........................................................................ 268
● Data Source.......................................................................................................... 268
● Modulation Settings...............................................................................................273
● Filter Settings........................................................................................................ 276
● Power Ramp Control Settings...............................................................................277
● Data List Editor......................................................................................................280
● Control and Marker Lists Editor.............................................................................282
4.6.3.1 General Settings
Access:
► Select "Baseband > Custom Dig Mod".
This tab provides access to the default and the Save/Recall settings, as well as to a
quick selection of a digital modulation according to predefined communication stan-
dard.
Generating Custom Digital Modulated Signals