Rohde & Schwarz SMW200A - Page 293

Configuring the Internal Baseband Source
R&S
®
SMW200A
278User Manual 1175.6632.02 ─ 16
The dialog comprises the settings used to configure the power ramping, like the source
of the control signals, the form of the ramp function and the applied attenuation.
See also "Power Ramping and Level Attenuation" on page 232.
Power ramping is possible up to a symbol rate of 5 MHz. A higher symbol rate disables
the power ramping automatically and an error message is output.
Settings:
State............................................................................................................................278
Source.........................................................................................................................279
Ramp Function............................................................................................................279
Ramp Time..................................................................................................................279
Rise Delay...................................................................................................................279
Fall Delay.................................................................................................................... 279
Attenuation..................................................................................................................279
In Baseband Only........................................................................................................280
State
Enables/disables power ramping.
Generating Custom Digital Modulated Signals