Configuring the Internal Baseband Source
R&S
®
SMW200A
310User Manual 1175.6632.02 ─ 16
Create Multi Carrier
Accesses the dialog for creating multi-carrier waveforms (see Chapter 4.9, "Generating
Multi-Carrier Signals", on page 354).
Create Test Signal...
Selects the form of the test signal and accesses the dialog with further settings. A
choice between a sinusoidal, rectangular, or test signal with constant I/Q is provided.
See the corresponding section for a detailed description of the parameters for the
selected test signal:
●
Chapter 4.7.3.2, "Sine Test Signals", on page 311
●
Chapter 4.7.3.3, "Rectangular Test Signal", on page 312
●
Chapter 4.7.3.4, "Constant IQ Test Signal", on page 314
Generation of test signals is possible in configurations with separated baseband sour-
ces ("System Configuration > Fading/Baseband Config > BB Source Configuration >
Separated").
Using the Arbitrary Waveform Generator (ARB)
To Next Page
Loading...
