Configuring the Internal Baseband Source
R&S
®
SMW200A
319User Manual 1175.6632.02 ─ 16
Alternatively, use the "New" function to add the R&S SMW manually to the list of
instruments.
4. Close the dialog.
5. In the block diagram, select "Vector Sig Gen" block and select the R&S SMW form
the list.
6. In the block diagram, select "ARB Sig Gen" block and select the R&S SMW form
the list.
The two lines to the "Vector Sig Gen" and "ARB Sig Gen" blocks on the block dia-
gram confirm that a remote connection to the R&S SMW is established.
Using the Arbitrary Waveform Generator (ARB)
To Next Page
Loading...
