Configuring the Internal Baseband Source
R&S
®
SMW200A
320User Manual 1175.6632.02 ─ 16
To generate a waveform file with the R&S WinIQSIM2
1. In the block diagram of R&S WinIQSIM2, select "Baseband > EUTRA/LTE".
2. Adjust the settings as required, for example:
a) select "Link Direction > Downlink"
b) select a predefined test model, "Test Setups/Models > E-TM1_1__10MHz"
3. Enable "EUTRA/LTE > State > On".
Using the Arbitrary Waveform Generator (ARB)
To Next Page
Loading...
