Configuring the Internal Baseband Source
R&S
®
SMW200A
332User Manual 1175.6632.02 ─ 16
New List
Accesses the standard "Create Multi Segment Waveform List" function to enter the
name of the new file.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:SELect on page 942
Load List
Accesses the standard "File Select" function to select the configuration file to be edi-
ted.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:CATalog? on page 940
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:SELect on page 942
Save List/Save List As...
Saves the current entries of the Segment Table in a configuration list (file), including
the level mode, clock mode, segment marker mode, and output file name settings.
See also Chapter 4.8.2.3, "File Concept", on page 326.
Consider also the following remote control commands:
●
To define the configuration file (*.inf_mswv) used by the calculation of the output
file:
– [:SOURce<hw>]:BB:ARBitrary:WSEGment:CREate
– [:SOURce<hw>]:BB:ARBitrary:WSEGment:CLOad
●
To define the file name of the output waveform file (*.wv):
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:OFILe
Remote command:
n.a.
Sequencing List
Accesses the dedicated dialog for configuring the associated play lists, see Chap-
ter 4.8.3.4, "Multi-Segment Waveform Sequencing", on page 337.
This function is enabled, if a multi segment file is created or created and loaded.
Remote command:
n.a.
Comment
Adds a comment to the composed multi-segment file.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:COMMent on page 941
Output file
Accesses the standard "File Select" dialog function and requests the file name for the
multi-segment waveform to be calculated.
An output file name is required for further processing of the multi-segment waveform:
●
For the internal storage triggered by the "Save List" function
●
For the calculation and creation of the multi-segment waveform, triggered by the
"Create" or "Create and Load" function.
Generating Multi-Segment Waveform Files
To Next Page
Loading...
