Rohde & Schwarz SMW200A - Next Segment Trigger in Settings

Configuring the Internal Baseband Source
R&S
®
SMW200A
342User Manual 1175.6632.02 ─ 16
4.8.3.5 Next Segment Trigger In Settings
The "Next Segment Trigger" settings are enabled only if a multi-segment waveform is
loaded into the ARB.
Access:
1. Enable a multi-segment waveform and load it in the ARB, see Chapter 4.8.3,
"Multi-Segment Settings", on page 330.
2. Select "Baseband > ARB > Trigger In (MSW)".
The "Next Segment Trigger In" section comprises the settings necessary to adjust
the trigger for switching between the segments of a multi-segment waveform. The
parameters displayed depend on the selected trigger source.
Settings:
Current Segment/Current Segment Index...................................................................343
Segment......................................................................................................................343
Next Segment Mode................................................................................................... 343
Next Segment Source.................................................................................................344
Level Mode..................................................................................................................344
Generating Multi-Segment Waveform Files