Rohde & Schwarz SMW200A - Page 392

Configuring the Internal Baseband Source
R&S
®
SMW200A
377User Manual 1175.6632.02 ─ 16
Settings:
Table Setup Assistant................................................................................................. 377
└ Carrier Start/Stop..........................................................................................377
└ Carrier State..................................................................................................377
└ Power Start................................................................................................... 377
└ Power Step................................................................................................... 378
└ Phase Start................................................................................................... 378
└ Phase Step................................................................................................... 378
└ Accept...........................................................................................................378
Carrier Table............................................................................................................... 378
Table Setup Assistant
Enables joint configuration of selectable range of carriers.
Carrier Start/Stop ← Table Setup Assistant
Defines the start/stop index of the carrier range to which the following settings are
intended to apply.
Remote command:
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STARt on page 995
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STOP on page 995
Carrier State ← Table Setup Assistant
Switches the carriers in the carrier range on/off.
Remote command:
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STATe on page 995
Power Start ← Table Setup Assistant
Sets the power of the starting carrier.
Generating Multi-Carrier Continuous Wave Signal