Configuring the Internal Baseband Source
R&S
®
SMW200A
388User Manual 1175.6632.02 ─ 16
●
A spectrum analyzer is connected to the R&S SMW, the analyzed is configured
and measures the required signal characteristics.
To shift the generated baseband signal
► Select "Baseband > Baseband Offsets > Frequency Offset" and apply an offset to
the generated baseband signal.
To verify the characteristics of the generated signal and to observe the effect of
applied frequency offset and gain
► Use the built-in real-time graphical display.
Refer to Chapter 2.3.6, "Verifying the Generated Signal with the Graphics Display",
on page 83 for an example.
Shifting and Boosting the Baseband Signal
To Next Page
Loading...
