Configuring the Signal in the RF Domain
R&S
®
SMW200A
484User Manual 1175.6632.02 ─ 16
2. Select "List Mode Data".
This dialog contains the parameters required for creating and editing lists, activat-
ing the learning function and selecting the list processing mode.
Settings
List Mode Data ...........................................................................................................484
Edit List Mode Data ....................................................................................................484
List Range from/to ......................................................................................................485
Run Mode....................................................................................................................485
Learn List Mode Data .................................................................................................485
List Mode Data
Accesses the standard "Select List" dialog for selecting, creating and editing a list file.
The currently loaded file is indicated.
You can create data lists with the internal editor or import externally created files, see
"Creating and handling lists" on page 471.
Remote command:
[:SOURce<hw>]:LIST:CATalog? on page 1084
[:SOURce<hw>]:LIST:SELect on page 1085
[:SOURce<hw>]:LIST:DELete on page 1084
[:SOURce<hw>]:LIST:DELete:ALL on page 1084
Edit List Mode Data
Opens the editor to insert and save data lists with RF frequency, power and dwell time
value pairs, see Chapter 7.6.7, "List Editor", on page 486.
You find this function also in standard file select dialog, accessed via List Mode Data .
Varying the RF Signal in List or Sweep Mode
To Next Page
Loading...
