Configuring the Signal in the RF Domain
R&S
®
SMW200A
502User Manual 1175.6632.02 ─ 16
Pulse Generator
The high performance pulse generator enables you to generate single or double pulse
signals.
Single
1 = Pulse Period 2 = Pulse Width 3 = Pulse Delay
Double
1 = Pulse Period 2 = Pulse Width
3 = Double Pulse Width 4 = Double Pulse Delay
To configure the associated parameters of the pulse generator, see LF Generator.
7.7.3 Modulation Settings
Access:
► Select "RF > Analog Modulation".
The "Modulation" dialog contains all functions and settings to configure the analog
modulations, the LF signal sources for performing a modulation, and the LF signal
output. The settings are arranged in several tabs according to their topics.
The remote commands required to define these settings are described in Chap-
ter 13.18.3.1, "SOURce:AM Subsystem", on page 870, Chapter 13.18.3.2,
"SOURce:FM Subsystem", on page 874, Chapter 13.18.3.3, "SOURce:PM Subsys-
tem", on page 877, Chapter 13.18.3.4, "SOURce:PULM Subsystem", on page 881
and Chapter 13.18.10, "SOURce:LFOutput Subsystem", on page 1061.
Analog Modulations
To Next Page
Loading...
