Rohde & Schwarz SMW200A - Fill with Sensor

Configuring the Signal in the RF Domain
R&S
®
SMW200A
535User Manual 1175.6632.02 ─ 16
The settings are interdependent; the affected parameters change accordingly if you set
a value.
To fill the table, select "Fill".
Note: Save a list only after filling all columns and rows, otherwise the entries are lost.
"From / Range"
Defines the start line and number of the row to be filled.
"Select Column to Fill"
Selects the respective value, including the unit.
"Start / End Value"
Provides the default values corresponding to the selected column.
"Increment"
Determines the step size.
"Fill"
Fills the table.
Fill both columns and then save the list. Otherwise the entries are
lost.
7.8.3.3 Fill with Sensor
Access:
1. Select "RF" > "RF Level" > "User Correction".
2. Select "User Cor. Data > navigate to the file *.ucor > Select".
Improving Level Performance