Rohde & Schwarz SMW200A - Page 554

Configuring the Signal in the RF Domain
R&S
®
SMW200A
539User Manual 1175.6632.02 ─ 16
"Decimal
Point"
Sets "Point" (dot) or "Comma" as the decimal separator used in the
ASCII data with floating-point numerals.
"Column Separator"
Sets the separator between the columns in an ASCII table.
Available are: "Tab", "Semicolon", "Comma" or "Space".
Remote command:
[:SOURce<hw>]:LIST:DEXChange:AFILe:EXTension on page 1086
[:SOURce<hw>]:LIST:DEXChange:AFILe:SEParator:DECimal on page 1087
[:SOURce<hw>]:LIST:DEXChange:AFILe:SEParator:COLumn on page 1087
[:SOURce<hw>]:CORRection:DEXChange:AFILe:EXTension on page 1034
[:SOURce<hw>]:CORRection:DEXChange:AFILe:SEParator:DECimal
on page 1034
[:SOURce<hw>]:CORRection:DEXChange:AFILe:SEParator:COLumn
on page 1034
Select Source/Select Destination
In "Mode > Import", access the file select dialog that provides standard file handling
functions.
Where:
●
"Select ASCII Source": defines the file to be loaded (imported)
●
"Select ASCII Destination": selects the filename the loaded file is saved as
Remote command:
[:SOURce<hw>]:LIST:DEXChange:AFILe:CATalog? on page 1086
[:SOURce<hw>]:LIST:DEXChange:AFILe:SELect on page 1086
[:SOURce<hw>]:CORRection:DEXChange:AFILe:CATalog? on page 1033
[:SOURce<hw>]:CORRection:DEXChange:AFILe:SELect on page 1034
Select Source / Select ASCII Destination
In "Mode > Export", access the file select dialog that provides standard file handling
functions.
Where:
●
"Select Source": selects the file to be exported
●
"Select ASCII Destination": defines the filename and the file path the exported file
is saved as
Remote command:
[:SOURce<hw>]:LIST:DEXChange:SELect on page 1087
[:SOURce<hw>]:CORRection:DEXChange:SELect on page 1035
Import / Export
Imports or exports the selected data list file, depending on the current mode.
Remote command:
[:SOURce<hw>]:LIST:DEXChange:EXECute on page 1086
[:SOURce<hw>]:CORRection:DEXChange:EXECute on page 1035
Improving Level Performance