Rohde & Schwarz SMW200A - Page 584

Monitoring Signal Characteristics
R&S
®
SMW200A
569User Manual 1175.6632.02 ─ 16
Figure 8-9: Graphics configuration dialog with active graphical signal displays
5. To enlarge the thumbnail, select it.
Settings:
Graphical Diagrams Table.......................................................................................... 569
Mode........................................................................................................................... 570
Source.........................................................................................................................570
Mux Stream.................................................................................................................570
FFT Length..................................................................................................................570
Full Scale (dBFS)........................................................................................................570
Trigger Source............................................................................................................ 570
Sample Rate Mode..................................................................................................... 571
Sample Rate............................................................................................................... 571
Add..............................................................................................................................571
Change........................................................................................................................571
Remove.......................................................................................................................571
Graphical Diagrams Table
The active graphical signal displays are listed in the table at the top of the dialog.
Displaying Baseband Signal Characteristics in Real-Time