Monitoring Signal Characteristics
R&S
®
SMW200A
571User Manual 1175.6632.02 ─ 16
"Marker 1"
The starting point for recording of signals is determined by the marker
1 setting of the activated digital standard ("Trigger/Marker" dialog).
This synchronous method is suitable if specific signal segments are
to be shown in greater detail. With periodic signals, a static image is
obtained by selecting a period length of marker 1 that is equal to the
signal period.
The displayed signal segment can be shifted by entering a marker
delay in the "Trigger/Marker" dialog of the activated digital standard.
Remote command:
[:SOURce<hw>]:BB:GRAPhics:TRIGger:SOURce on page 1019
Sample Rate Mode
Sets how the time resolution of the signal is determined. Maximum resolution corre-
sponds to a display covering the entire signal bandwidth. The higher the resolution, the
shorter the length of the displayed signal segment.
"Auto"
The resolution is set to an optimum value in terms of signal and dis-
play type.
"Full Bandwidth"
The resolution is set so that the display covers the entire signal band-
width.
"User"
Activates the "Sample Rate" input field, where you can manually set
the resolution.
Remote command:
[:SOURce<hw>]:BB:GRAPhics:SRATe:MODE on page 1016
Sample Rate
●
If "Sample Rate Mode = Auto/Full Bandwidth"
Displays the percentage of the entire signal bandwidth which is used for the graphi-
cal signal display.
●
If "Sample Rate Mode = User"
Input for the percentage of signal bandwidth which is used for the graphical signal
display.
Remote command:
[:SOURce<hw>]:BB:GRAPhics:SRATe:USER on page 1016
Add
Adds a graphical signal display (as set in the "Graphics Configuration" dialog) to the
taskbar/graphical diagrams table.
Remote command:
[:SOURce]:BB:GRAPhics:ADD on page 1017
Change
Enables the current settings for the selected graphical signal display.
Remove
Removes the selected graphical signal display from the taskbar/graphical diagrams
table.
Displaying Baseband Signal Characteristics in Real-Time
To Next Page
Loading...
