Multi-Instrument Setups
R&S
®
SMW200A
618User Manual 1175.6632.02 ─ 16
As with other downstream instruments, the frequency and level indications in the
R&S SMW status bar show the R&S SZU values. Parameters like the frequency and
level offset, level limits, delta phase or RF output state affect the RF output of the R&S
SZU.
The remote commands required to define the R&S SZU settings are the same as the
R&S SMW commands, so that you can reuse your SCPI scripts. Note the changes in
the value ranges and the commands usage listed in chapter "Remote Control" in the
description SZU100A Getting Started.
For step-by-step description, see:
●
Chapter 3.9.6, "How to Connect and Configure External Instruments", on page 198
9.4.5 Further Information
For step-by-step descriptions, see:
●
Chapter 3.9, "How to Connect External Instruments and Configure the Signal
Flow", on page 191
For information on the possible scenarios and test setups, see:
●
Chapter 3.1.2, "From a Test Scenario to the Required System Configuration",
on page 124
For description of the settings related to connection establishment, see:
●
Chapter 3.4.3, "External RF and I/Q Settings", on page 147
●
Chapter 3.4.2, "I/Q Stream Mapper Settings", on page 144
For information on the manual and remote control operation of the external instru-
ments, see the documentation of the particular instrument:
●
For R&S SZU, see the SZU100A Getting Started
●
For R&S SGT, see the SGT100A User Manual
Control and Operation of External Instruments
To Next Page
Loading...
