Rohde & Schwarz SMW200A - Configuring the Initial Instrument Settings

Getting Started
R&S
®
SMW200A
49User Manual 1175.6632.02 ─ 16
To assign the IP address manually on the computer
► Obtain the necessary information from your network administrator. If you use more
than one LAN connector, you need separate address information for each connec-
tor.
For information on how to perform the configurations, refer to the documentation of
the operating system the computer uses.
2.1.5 Configuring the Initial Instrument Settings
This section describes how to set up the R&S SMW initially.
2.1.5.1 Setting the Date and Time
The R&S SMW uses an internal real-time clock to determine the date and time. By
default, the instrument is set to the UTC timezone, but you can select the timezone
according to your location.
To select the timezone
1. Press the SETUP key.
2. Select "Maintenance > Timezone".
3. Select continent and city of your location.
Tip: By typing the first letter, you can quickly navigate through the lists to find the
desired destination.
Preparing for Use