Rohde & Schwarz SMW200A - GUI Appearance Settings

General Instrument Functions
R&S
®
SMW200A
659User Manual 1175.6632.02 ─ 16
Remote command:
:KBOard:LAYout on page 808
11.1.2 GUI Appearance Settings
► To access this dialog, select "System Config > Setup > User Interface > Appear-
ance".
In this dialog, you can set inactive dialog opaque and enable the display of dialog
snapshots.
Display Dialog Snapshots
Displays thumbnails of open dialogs in the task bar.
Alpha Settings (inactive dialogs)
Activates the transparency of inactive dialogs.
11.1.3 Display Update Settings
Access:
► Select "System Config > Setup > User Interface > Start/Stop Display Update".
This dialog enables you, to deactivate updating the display.
The remote command to switch off the ddiplay update is described in Chapter 13.11,
"DISPlay Subsystem", on page 796.
Customizing the User Interface