General Instrument Functions
R&S
®
SMW200A
665User Manual 1175.6632.02 ─ 16
Figure 11-1: Internal resources for the marker and trigger signals
* = Pulse In/Out A/B, Sync A/B, Signal Valid A/B
** = Lev Att, Burst Gate, CW/Mod, Hop, Triggered
The baseband couple A/C is implemented on the same hardware, CODER board, and
hence share the T/M/C1/2/3 connectors. The baseband B/D couple share the T/M/
C4/5/6 connectors.
11.2.3 Trigger Marker Clock Settings
Access:
1. Perform one of the following:
● In the "Block Diagram", select the T/M/C status LEDs on the left side of the
"Baseband" blocks.
● Select "Baseband > Trigger Marker Clock".
The "Trigger Marker Clock" gives an overview of the current mapping of the logical
signals to the connectors, as configured in the Global Connectors and Local Con-
nectors dialogs. A click on the connector name accesses directly the related con-
nector settings.
The dialog consists of several tabs, each tab corresponds to one of the available
basebands.
Configuring the Local and Global Connectors
To Next Page
Loading...
