General Instrument Functions
R&S
®
SMW200A
687User Manual 1175.6632.02 ─ 16
– Volatile mode that prevents information to be written to the hard disk memory
permanently.
– Sanitizing that prevents the instrument from leaving a secure environment with
stored user information.
– Annotation frequency and amplitude prevent reading the display.
To access the settings of these topics, see Chapter 11.5.2, "Setting Security
Parameters", on page 688.
●
Password management secures controlled user access to the instrument
With the two-step password concept, you can assign a user-defined password for
the operating system, and a security password for accessing the mass storage of
the instrument.
See also Chapter 11.5.2, "Setting Security Parameters", on page 688.
●
LAN services secure controlled network access
You can individually lock and unlock the supported LAN interface services, see
Chapter 11.5.3, "Configuring LAN Services", on page 692.
Remote control via LAN interface requires that the interface is activated, but you
can enable the required services specifically.
●
User interface prevents front panel operation and/or reading the display.
For more information, see the document R&S SMW Instrument Security Procedures.
11.5.1 Protection Level Settings
Access:
► Select "System Config > Setup > Security > Protection".
The "Protection" dialog provides access to the unlocking of different protection lev-
els.
Several functions in the instrument are password-protected to prevent for example
accidental changes, "Protection" on page 686.
Managing the Security Settings
To Next Page
Loading...
