Network Operation and Remote Control
R&S
®
SMW200A
762User Manual 1175.6632.02 ─ 16
The default password is instrument.
After the connection is established, the current screen of the signal generator is
displayed and the instrument can be remotely operated.
12.17.2.3 Special Mode QR Code
If your smart device is equipped with a camera and a QR code reader, you can scan
the instrument's IP address or access the instrument with the Safari web browser.
QR code readers are available from various manufacturers of the smart devices. The
list of supported devices is different according to the smart device. Refer to the manu-
facturer's website to find out whether a reader is available for your device, and how it is
installed.
1. Install the required QR code reader software on your device.
2. Start the reader.
3. On the R&S SMW, select "System Config > Remote Access".
4. In the "Remote Access" dialog, select the "QR-Code" tab.
5. Scan the QR code of the instrument with your smart device.
6. On the device, decode the scanned QR code and pass it to the web browser.
A dialog opens requesting the password for the VNC connection.
7. Enter the password and confirm with "OK".
The default password is instrument.
After the connection is established, the current screen of the signal generator is
displayed and the instrument can be remotely operated.
12.18 References
12.18.1 LXI Functionality
LAN Extensions for Instrumentation (LXI) is an instrumentation platform for measuring
instruments and test systems that is based on standard Ethernet technology. LXI is
intended to be the LAN-based successor to GPIB, combining the advantages of Ether-
net with the simplicity and familiarity of GPIB.
Like GPIB, LXI determines and standardizes the way the instrument behaves in a LAN.
The LXI implementation in the R&S SMW allows you to change certain LAN settings,
to reset the LAN connection, and to identify the instrument.
References
To Next Page
Loading...
