Remote Control Commands
R&S
®
SMW200A
794User Manual 1175.6632.02 ─ 16
Usage: Query only
Manual operation: See "Adjust LO Level at Current Frequency" on page 453
13.9 CLOCk Subsystem
The CLOck subsystem contains the commands for configuration of the signals at the
clock input and output connectors.
:CLOCk:INPut:FREQuency?
Returns the measured frequency of the external clock signal.
Return values:
<Frequency> float
Range: 0 to max
Increment: 0.001
*RST: 0
Example:
:CLOCk:INPut:FREQuency?
Usage: Query only
Options: R&S SMW-B10
Manual operation: See "Measured External Clock" on page 261
13.10 DIAGnostic Subsystem
The DIAGnostic subsystem contains the commands used for instrument diagnosis
and servicing. SCPI does not define any DIAGnostic commands; the commands lis-
ted here are all device-specific. All DIAGnostic commands are query commands
which are not affected by *RST.
The test functions are intended for services purposes.
They are thus password-protected functions. Unlock the corresponding protection level
to access them, see :SYSTem:PROTect<ch>[:STATe]
For more information, see R&S SMW Service Manual.
Common suffixes
The following common suffixes are used in remote commands:
Suffix Value range Description
DIAGnostic<hw>
[1] | 2 Signal path
DIAGnostic Subsystem
To Next Page
Loading...
