Rohde & Schwarz SMW200A - Page 881

Remote Control Commands
R&S
®
SMW200A
866User Manual 1175.6632.02 ─ 16
[:SOURce<hw>]:BBIN:MODE..........................................................................................867
[:SOURce<hw>]:BBIN:SRATe:SOURce........................................................................... 867
[:SOURce<hw>]:BBIN:SRATe[:ACTual]............................................................................867
[:SOURce<hw>]:BBIN:DIGital:ASETting:STATe................................................................867
[:SOURce<hw>]:BBIN:MPERiod......................................................................................868
[:SOURce<hw>]:BBIN:ALEVel:EXECute.......................................................................... 868
[:SOURce<hw>]:BBIN:CFACtor.......................................................................................868
[:SOURce<hw>]:BBIN:POWer:PEAK............................................................................... 868
[:SOURce<hw>]:BBIN:POWer:RMS?...............................................................................869
[:SOURce<hw>]:BBIN:OLOad:STATe?............................................................................ 869
[:SOURce<hw>]:BBIN:OLOad:HOLD:STATe?.................................................................. 869
[:SOURce<hw>]:BBIN:OLOad:HOLD:RESet.....................................................................870
[:SOURce<hw>]:BBIN:CDEVice?.....................................................................................870
[:SOURce<hw>]:BBIN:STATe <State>
Switches the feeding of an external analog signal into the signal path on/off.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Programming Example" on page 865
Manual operation: See "State" on page 173
[:SOURce<hw>]:BBIN:DIGital:SOURce <DigInpSource>
Defines the connector used as an external signal source.
Parameters:
<DigInpSource> CODER1 | FADER1 | FADER2 | CODER2
*RST: CODER1
Example: see Example "Programming Example" on page 865.
Manual operation: See "Source" on page 173
[:SOURce<hw>]:BBIN:IQSWap[:STATe] <State>
If activated, swaps the I and Q channel.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: see Example "Programming Example" on page 865
Manual operation: See "I/Q Swap" on page 173
SOURce Subsystem