Remote Control Commands
R&S
®
SMW200A
868User Manual 1175.6632.02 ─ 16
Manual operation: See "DIG IQ Auto Setting" on page 175
[:SOURce<hw>]:BBIN:MPERiod <MPeriod>
For [:SOURce<hw>]:BBIN:DIGital:SOURceCODER1|CODER2, sets the recording
duration for measuring the baseband input signal by executed [:SOURce<hw>]:
BBIN:ALEVel:EXECute.
Parameters:
<MPeriod> integer
Range: 1 to 32
*RST: 2
Default unit: s
Example: see Example "Programming Example" on page 865
Manual operation: See "Measurement Period" on page 176
[:SOURce<hw>]:BBIN:ALEVel:EXECute
For [:SOURce<hw>]:BBIN:DIGital:SOURceCODER1|CODER2, starts measuring
the input signal. The measurement estimates the crest factor, peak and RMS level.
Example:
See Example "Programming Example" on page 865
Usage: Event
Manual operation: See "Auto Level Set" on page 176
[:SOURce<hw>]:BBIN:CFACtor <CFactor>
Enters the crest factor of the external baseband signal.
Parameters:
<CFactor> float
Range: 0 to 30
Increment: 0.01
*RST: 0
Default unit: dB
Example: See Example "Programming Example" on page 865
Manual operation: See "Crest Factor" on page 176
[:SOURce<hw>]:BBIN:POWer:PEAK <Peak>
Peak level of the external baseband signal relative to full scale of 0.5 V (in terms of dB
full scale).
SOURce Subsystem
To Next Page
Loading...
