Remote Control Commands
R&S
®
SMW200A
872User Manual 1175.6632.02 ─ 16
The following commands are available:
[:SOURce<hw>]:AM:RATio............................................................................................. 872
[:SOURce<hw>]:AM:SENSitivity?.................................................................................... 872
[:SOURce<hw>]:AM<ch>:SOURce.................................................................................. 872
[:SOURce<hw>]:AM<ch>:STATe.....................................................................................873
[:SOURce<hw>]:AM<ch>[:DEPTh]...................................................................................873
[:SOURce<hw>]:AM:RATio <Ratio>
Sets the deviation ratio (path#2 to path#1) in percent.
Parameters:
<Ratio> float
Range: 0 to 100
Increment: 0.01
*RST: 100
Example: See Example "Creating an amplitude modulated RF signal"
on page 870.
Manual operation: See "Ratio Path2/Path1" on page 507
[:SOURce<hw>]:AM:SENSitivity?
Queries the sensitivity of the externally applied signal for amplitude modulation. The
sensitivity depends on the set modulation depth.
The returned value reports the sensitivity in %/V. It is assigned to the voltage value for
full modulation of the input.
Return values:
<Sensitivity> float
Range: 0 to 100
Example: See Example "Using an external signal source" on page 871.
Usage: Query only
[:SOURce<hw>]:AM<ch>:SOURce <Source>
Selects the modulation source for amplitude modulation.
Suffix:
<ch>
.
1 to 2
Modulation signal channel
SOURce Subsystem
To Next Page
Loading...
