Getting Started
R&S
®
SMW200A
82User Manual 1175.6632.02 ─ 16
To map the I/Q stream and define the output connector
The term stream describes the signal at the input of the "I/Q Stream Mapper" up to the
output connectors of the instrument.
1. In the block diagram, select the "I/Q Stream Mapper" block.
The "System Configuration > I/Q Stream Mapper" dialog displays the current
(default) distribution and mapping of the I/Q streams to the output connectors as a
mapping matrix.
Stream A is routed to all the available output connectors: the analog RF A and I/Q
("I/Q OUT 1") connectors, and the digital I/Q output connectors DIG I/Q
("BBMM1").
2. To reconfigure the mapping, tap a matrix entry, for example disable the output of
stream A on the BBMM 1 interface.
With the "I/Q Stream Mapper", you route the streams; the outputs are, however,
not necessarily activated.
Tip: How to access the settings of the input and output interfaces.
In the block diagram, the blocks related to the input and output interfaces can be
folded for a better overview.
If the block diagram does not show the "I/Q Analog" block, tap the corresponding
connector icon, i.e. "I/Q Out 1/2", to unfold the settings.
Trying Out the Instrument
To Next Page
Loading...
