Getting Started
R&S
®
SMW200A
83User Manual 1175.6632.02 ─ 16
The generated composed signal (stream A) is output at the analog RF A connector
and routed to the I/Q OUT 1 connector. The block diagram confirms this routing
and displays the letter "A" next to the symbols of the output connectors.
Consider however that the I/Q connectors are disabled.
To learn more and to explore the whole range of routing capability, refer to Chapter 3,
"Signal Routing and System Configuration", on page 122.
2.3.6 Verifying the Generated Signal with the Graphics Display
It is often useful to check the spectra of the configured signals, before you enable the
RF output of the instrument.
The R&S SMW provides a build-in function to represent the generated signal on a
graphical signal display. We demonstrate this feature by showing the characteristics at
one particular point of the signal processing chain. You can, however, display the sig-
nal characteristics at other different stages.
This example shows you how to use this graphical display to verify the generated sig-
nal. Use the signal generated in Chapter 2.3.5, "Routing the Signal through the Instru-
ment and Defining the Output Connectors", on page 78.
To access the graphical signal display functionality
► Perform one of the following:
Trying Out the Instrument
To Next Page
Loading...
