Chapter 5 Operation
5300.9677.71 - 5.42 - EN-4
Audio Ch2 Status of channel 2 (secondary audio input = standby):
(the input type is set in the "Input > Automatic Input" menu window)
– OK
Channel 2 is functioning normally.
– One Ch. Not OK
In the case of Stereo or Mono L+R modulation, this status is displayed
if just one of the two feeds for left and right is functioning normally
while the other feed is faulty.
– Not OK
Channel 2 has failed completely
– Not used
No standby input is defined.
Data Input Sum status of the data inputs:
– OK
All data inputs are functioning normally or are switched off.
– Warning
At least one data input is faulty.
Local Local or remote operation:
– No
Remote operation: the parameters for the exciter can only be read out
on the display and via the web browser.
– Yes
Local operation: the parameters for the exciter can both be read out
and set (full access) on the display and via the web browser.
Interlock – No
RF interlock loop closed
– Yes
RF interlock loop not closed
Mute Internal deactivation of the RF output of the exciter:
– No
The RF output of the exciter is not disabled (normal status)
– Yes
The RF output of the exciter is internally disabled (when the interlock
loop is open or when changing frequency)
Ext. Ref. Status of an external reference source:
– Off
No external reference connected; the internal TCXO is used
– OK
External reference frequency is present and is OK
– Not OK
External reference frequency is not present or is not OK
Display Explanation
To Next Page
Loading...
