Rohde & Schwarz SR8100 - Configuring Transmitter Standby and Remote-Control Interface

Chapter 4 Putting into Operation
5300.9677.72 - 4.8 - EN-4
2. Switch Additional Amplifier to present.
3. Restart the system.
The separate amplifier is then logged on and the software on the R&S SR8250A system
is configured.
2.2.4 Configuring Transmitter Standby and Remote-Control Inter-
face
In the System menu window, you can configure an existing standby system and the parallel
remote-control interface.
) Select Transmitter > Setup > System.
The System window opens.
You can enter the following settings in the System window:
Selection Description
Transmitter ID User-definable ID (e.g. name) of the transmitter
Model Must be set to Transmitter